פיקאפ איכותי לבנג'ו JJB ELECTRONICS BANJO P PB-200

The L-shaped part of the jack assembly is made from a very
durable and dense plastic. It has been stress tested up to 60lbs.
It is made to stand the test of time. The threaded back strip is
made from steel. This assembly is a JJB-ELECTRONICS
exclusive. You won't find a better one anywhere else!

The output jack assemblies allow you to attach a standard 1/4"
output to your banjo without drilling any holes in the instrument
or modifying it in any manner. The design of these jack
assemblies allow them to attach to the tensioning hooks in the
same manner that an arm rest is attached. These units are
designed to fit almost any banjo known to man. They will fit
banjos with hook spacings from 1 1/8" up to 1 15/16".The
transducers mount to the bottom of the head under the bridge
using the provided double-stick material.

Our new line of pickups are constructed with the finest
components available. In fact, they are the same (Better, in many
cases) components that are used by other companies that sell
their systems for far more money. We welcome you to shop
around to see what similar systems are selling for.

These are built using very high quality 20mm piezo's. These can
be used with or without a preamp with fantastic results.

Both systems utilize a double surface transducer design. This
results in a very wide frequency range and very natural
reproduction of sound. The two-piezo configuration offers a few
advantages over single piezo systems. Having two piezo’s
affords you the opportunity to place them at two different points
on the soundboard thus resulting in an improved dynamic range
due to the fact that they transmit the resonance found at more
than one point. These special surface transducers are under
less pressure than under saddle pickups thus decreasing the
likelihood of them transmitting a percussive or harsh sound.
These do not "fade" or distort at high volume or with high-
power systems. The highs are crystal clear while the lows are
what they should be, low!

These, like all of our systems, can be installed in about 15
minutes. They are a very simple and inexpensive means of
turning your acoustic instruments in to acoustic electric.